Model Tech P-47 Thunderbolt Especificaciones descargar pdf (Pagina 55)

See other exciting Modeltech ARF airplanes at http://modeltech.globalhobby.com

❑ Using a modeling knife, rough-cut the support block close

to its final shape.

❑ Sand the support block smooth and straight using 220

grit sandpaper and a sanding block.

☞

You want the support block to be straight across from

the inside edge to the outside edge.

❑ Test-fit balsa support block W74 into the middle of the

wing fairing. Note the angle the block is installed at.

❑ Glue the block into place, then trim it to shape using the

same technique as before.

☞

There will be a gap between the block and the outer

edge of the fairing. This is okay.

❑ Test-fit balsa support block W75 near the front of the

wing fairing. Note the angle the block is installed at.

❑ Glue the block into place, then trim it to shape using the

same technique as before.

☞

There will be a gap between the block and the outer

edge of the fairing. This is okay.

❑ Repeat the previous procedures to install the three balsa support blocks into the second wing fairing.

Step 3: Installing the Wing Fairings

❑ Set one wing fairing onto the wing and realign it. Use

pieces of masking tape to hold it securely in place.

❑ Using a pencil, outline the outer edge of the fairing onto

the wing.

IMPORTANT

The wing fairings are glued only to the wing. They are not

glued to the fuselage side.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 67 68

Sin comentarios

Model Tech P-47 Thunderbolt Especificaciones Pagina 55