Model Tech P-47 Thunderbolt Especificaciones descargar pdf (Pagina 29)

See other exciting Modeltech ARF airplanes at http://modeltech.globalhobby.com

Step 4: Installing the Main Gear Wheels

❑ Slide one 60mm wheel, flat side toward the wing tip,

onto each axle.

❑ Slide one 4mm nylon spacer onto each axle, up against

the wheel.

❑ Secure each wheel in place using one 4mm wheel collar

and one 3mm x 5mm machine screw. Tighten the screws

firmly to secure the wheels in place.

Step 5: Installing the Plastic Wheel Cups

❑ Using a pair of scissors, cut off the excess flashing from

around the top of the two wheel cups, making sure to leave

about a 1/4" lip to use as a gluing surface.

❑ Using 220 grit sandpaper with a sanding block, sand the

edges of the wheel cups smooth.

❑ Using a modeling knife, carefully cut a 1/2" diameter

hole in the center of each wheel cup.

☞

This hole will allow clearance for the wheel collar when

the landing gear is retracted.

❑ Push one wheel cup down into place, making sure the

molded lip is firmly pushed against the surface of the wing.

❑ Carefully mark and cut a groove in the wheel cup so that

the strut will clear when retracted.

❑ Push the wheel cup back into place to double-check the

alignment.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 67 68

Sin comentarios

Model Tech P-47 Thunderbolt Especificaciones Pagina 29