Model Tech P-47 Thunderbolt Especificaciones descargar pdf (Pagina 54)

Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net

❑ Cut out the front and back of the wing fairings, being

careful to follow the molded edges closely.

❑ Cut the outer edge of the wing fairings along the molded

scribe line.

❑ Sand the edges of the wing fairings smooth and straight using 220 grit sandpaper with a sanding block.

Step 2: Installing the Balsa Support Braces

❑ Bolt the wing securely to the fuselage.

❑ Test-fit one wing fairing onto the wing. The notch near

the back of the fairing fits over the trailing edge of the wing

and the entire length of the fairing should fit firmly against

the top of the wing and the side of the fuselage.

IMPORTANT

The fairings are not difficult to install, but take your time and be careful. Taking some extra time now will result in tight-

fitting, great-looking wing fairings.

☞

There are three balsa support blocks installed into the bottom of each fairing. W76 goes near the back of the fairing,

W74 in the middle and W75 near the front of the fairing. The blocks are oversized so they can be trimmed and sanded

down to fit after being glued into place.

❑ Test-fit balsa support block W76 into the back of the

fairing. Note the angle the block is installed at.

❑ When satisfied with the fit, carefully glue the block in

place using a small amount of thin C/A.

WARNING

When installing the support blocks, be very careful that they

do not distort the fairing, especially the flat side that goes up

against the fuselage.

IMPORTANT

Remember to roughen the gluing surface prior to gluing the block into place.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 67 68

Sin comentarios

Model Tech P-47 Thunderbolt Especificaciones Pagina 54