Model Tech P-47 Thunderbolt Especificaciones descargar pdf (Pagina 34)

Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net

Step 2: Installing the Fuselage Servos

❑ Test-fit the servo tray onto the two preinstalled support

rails inside the fuselage. The sides of the tray should be equal

distances from the sides of the fuselage.

IMPORTANT

The tray should be installed so that the two closest servo

cutouts are toward the left side of the fuselage as shown.

❑ Install the three servos into the servo tray taking note of

the positions of the servo output shafts.

☞

To make it easier to install the servo mounting screws,

drill 1/16" pilot holes through the servo tray.

❑ Kwik Bond Thick C/A

❑ # 1 Phillips Head Screwdriver

❑ Excel Modeling Knife

YOU'LL NEED THE FOLLOWING PARTS:

❑ (1) Plywood Fuselage Servo Tray (D24)

SECTION 17: FUSELAGE SERVOS INSTALLATION

YOU'LL NEED THE FOLLOWING SUPPLIES:

❑ Electric Drill

❑ 1/16" Drill Bit

❑ Ernst Airplane Stand

Step 1: Installing the Fuselage Servo Tray

❑ Install the rubber grommets and brass collets onto your elevator, rudder and throttle servos. Make sure to install the

collets with the flanges toward the bottom of the servos.

❑ When satisfied with the fit, glue the servo tray into place using a generous amount of thick C/A.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 67 68

Sin comentarios

Model Tech P-47 Thunderbolt Especificaciones Pagina 34