Model Tech P-47 Thunderbolt Especificaciones descargar pdf (Pagina 49)

See other exciting Modeltech ARF airplanes at http://modeltech.globalhobby.com

❑ Remove the servo cover assembly and enlarge only the holes in the servo cover using a 3/32" drill bit.

❑ Reinstall the servo cover assembly using the four 3mm x 5mm wood screws provided.

❑ Repeat the previous procedures to install the second servo cover assembly in the other half of the wing.

Step 3: Installing the Aileron Pushrods

❑ Enlarge the fourth hole out from the center of one con-

trol horn using a 5/64" drill bit.

❑ Install the 90º bend in one 60mm long pushrod wire to

the servo arm using one nylon snap-keeper. When installing

the snap-keeper, make sure it "snaps" firmly into place over

the pushrod wire.

☞

The pushrod wire should be toward the outside of the

servo arm as shown.

❑ Repeat the procedures above to install the remaining aileron pushrod wire onto the second aileron servo arm.

Step 4: Installing the Aileron Control Horns & Clevises

❑ Use a couple of pieces of masking tape to hold one of the ailerons centered.

❑ Position one nylon control horn onto the bottom of the

aileron, aligning the centerline of the control horn directly

behind the servo arm.

☞

Make sure the control horn is perpendicular to the hinge

line and adjust the control horn so that the clevis attachment

holes are directly over the hinge line.

❑ Mark the positions of the mounting screws using a pencil, then remove the control horn.

❑ Carefully drill the holes for the mounting screws using a 5/64" drill bit.

IMPORTANT

Make sure to drill the holes straight down and not at an angle.

❑ Install the control horn and backplate using two 2mm x 30mm machine screws.

☞

Don't overtighten the screws. You don't want to crush the aileron.

❑ Connect your radio system and plug the aileron servo lead into its proper slot in the receiver. Double-check that the

aileron trim lever on your transmitter is centered.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 67 68

Sin comentarios

Model Tech P-47 Thunderbolt Especificaciones Pagina 49