Model Tech P-47 Thunderbolt Especificaciones descargar pdf (Pagina 35)

See other exciting Modeltech ARF airplanes at http://modeltech.globalhobby.com

❑ Kwik Bond Thin C/A

❑ # 1 Phillips Head Screwdriver

❑ Wire Cutters

❑ Excel Modeling Knife

YOU'LL NEED THE FOLLOWING PARTS:

SECTION 18: THROTTLE CONTROL SYSTEM INSTALLATION

YOU'LL NEED THE FOLLOWING SUPPLIES:

❑ Electric Drill

❑ 5/64" & 7/64" Drill Bits

❑ Ernst Airplane Stand

❑ (1) 2mm x 400mm Pushrod Wire w/Z-Bend ❑ (1) Adjustable Servo Connector Assembly

Step 1: Installing the Throttle Pushrod Wire

❑ Carefully drill a 7/64" hole through the firewall for the

throttle pushrod wire to enter the engine compartment.

IMPORTANT

The hole should line up with the throttle arm as closely as

possible, yet should be far enough to the side so the fuel tank

does not interfere with the pushrod when it's installed later.

IMPORTANT

Depending on your particular engine, you may need to bend the pushrod wire to line up better with the throttle arm.

Bending the pushrod wire will prevent any binding in the linkage.

❑ Slide the end of the pushrod wire through the hole in the

firewall and reinstall the throttle arm onto your engine.

☞

Unless you have a long drill bit, you may have to remove the engine to be able to drill the hole in the firewall.

❑ Remove the throttle arm from your engine.

❑ Install the Z-Bend in the throttle pushrod wire into the outermost hole in the throttle arm.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 67 68

Sin comentarios

Model Tech P-47 Thunderbolt Especificaciones Pagina 35