Model Tech P-47 Thunderbolt Especificaciones descargar pdf (Pagina 20)

Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net

❑ Kwik Bond Thin C/A

❑ Kwik Bond C/A Debonder

YOU'LL NEED THE FOLLOWING PARTS:

❑ (17) C/A Style Hinges

SECTION 12: CONTROL SURFACE HINGING

YOU'LL NEED THE FOLLOWING SUPPLIES:

❑ Ernst Airplane Stand

❑ Paper Towels

IMPORTANT

If you want flutter-free control surfaces it is imperative that the hinges be glued in properly. This includes both having a

tight hinge gap and using plenty of thin C/A glue.

Step 1: Hinging the Ailerons

❑ Slide one hinge into each of the four hinge slots in each

aileron.

❑ Center each hinge within its slot and double-check to

make sure the centerline of the hinges is flush with the

leading edge of the ailerons.

❑ Glue each hinge into place using 5-6 drops of thin C/A.

Allow a few seconds between drops for the C/A to "wick"

into the hinges, then turn the ailerons over and apply 5-6

drops on the other side of each hinge. Let the C/A dry for

about 10 minutes before proceeding.

☞

If any C/A gets onto the aileron, it can be removed promptly using a paper towel soaked with a small quantity of

Kwik Bond C/A Debonder.

❑ Slide the aileron and its hinges into the hinge slots in the trailing edge of the wing, making sure that the leading edge

of the aileron is pushed firmly up against the trailing edge of the wing. The edges of the aileron should not rub against the

edges of the wing.

❑ While holding the aileron tight against the wing, pivot

the aileron down about 45º and apply 5-6 drops of thin C/A

to the exposed area of each hinge. Turn the wing over and

repeat for the other side of the hinges.

☞

Remove any C/A that may run down the hinge line using

C/A Debonder.

❑ After the C/A has dried completely - about 15 minutes -

pivot the aileron up and down to free up the hinges.

IMPORTANT

After the C/A has fully cured, gently grasp the aileron and pull on it like you are trying to pull out the hinges. The hinges

should hold securely. If one or more hinges feels loose, apply more C/A to the hinge(s) and allow it to completely cure.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 67 68

Sin comentarios

Model Tech P-47 Thunderbolt Especificaciones Pagina 20