Model Tech P-47 Thunderbolt Especificaciones descargar pdf (Pagina 18)

Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net

❑ While holding the vertical stabilizer firmly in place,

use a builder's triangle to double-check that the vertical

stabilizer is aligned 90º to the horizontal stabilizer.

Step 2: Mounting the Vertical Stabilizer

❑ Mix and apply a generous amount of 30 minute epoxy to the bottom of the vertical stabilizer and to the slot in the

trailing edge of the horizontal stabilizer.

❑ Push the stabilizer down into place and realign it, double-checking all of your measurements once more before the

epoxy sets up. Quickly remove the excess epoxy and use pieces of masking tape to hold the stabilizer in place until the

epoxy has fully cured.

Step 3: Aligning the Stabilizer Assembly

❑ Using a modeling knife, remove the covering material

from the stabilizer gluing surfaces on the fuselage.

☞

Make sure to remove any covering that's inside the slot

in the back of the fuselage.

❑ Test-fit the stabilizer assembly to the fuselage. When

aligned properly, the mounting post should fit flush inside

the slot in the back of the fuselage, the stabilizer assembly

should be pushed down firmly, and the front of the stabilizer

assembly should be even with the fuselage sides and turtle deck.

❑ When satisfied with the alignment use pieces of masking tape to hold the stabilizer assembly firmly in place.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 67 68

Sin comentarios

Model Tech P-47 Thunderbolt Especificaciones Pagina 18