Model Tech P-47 Thunderbolt Especificaciones descargar pdf (Pagina 16)

Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net

IMPORTANT

You may need to sand an angle in the front of the belly pan so that it will fit flush with the surface of the wing.

❑ If there are any gaps between the belly pan and the wing, remove the belly pan and sand down any high spots using

a sanding block with 220 grit sandpaper. Remove small amounts of material at a time, checking the fit often.

❑ Using a Dremel tool with first a cutting disc, then a

sanding drum, cut out the back of the belly pan to allow

room for you to install and retrieve the wing bolts from

the wing.

WARNING

Make sure to leave enough material around the edges of the

belly pan for strength.

❑ Set the belly pan back into place and realign it.

❑ Using a pencil, carefully mark the locations of the two wing bolts onto the bottom of the belly pan.

☞

Before drilling the holes in the next procedure, apply a

couple of strips of masking tape onto the belly pan over where

the holes will be drilled. The masking tape will keep the

paint from chipping when drilling the holes.

❑ Using a 3/8" drill bit, drill two holes through the belly

pan at the locations you marked.

❑ Set the belly pan back onto the wing and realign it. Use several pieces of masking tape to hold it securely in place.

Step 2: Drilling the Wing Bolt Access Holes

Step 3: Installing the Belly Pan

❑ With the belly pan held firmly in place and aligned, use

a pencil to outline the sides of the belly pan onto the bottom

of the wing.

❑ Remove the belly pan from the wing.

❑ Using a modeling knife, carefully cut away and remove

a wide strip of covering material from inside the outlines you

drew.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Sin comentarios

Model Tech P-47 Thunderbolt Especificaciones Pagina 16