Model Tech Mini Mach Racer Especificaciones descargar pdf (Pagina 9)

Page 9

q Enlarge the hole in one servo arm that is 3/8" (10mm) out from the centre

of the servo horn, using a 1/16" (1.6mm) diameter drill bit.

q Install the Z-Bend in one pushrod wire into the hole that you enlarged in the

servo arm.

The pushrod wire should be orientated on top of the servo arm.

q Centre the elevon servo, then install the servo horn onto the servo, making

sure that the servo horn is centred and pointing out toward the wing tip.

q Install the servo horn retaining screw to secure the servo horn to the servo.

q With both the servo horn and the elevon centred, thread one clevis onto the

pushrod wire and snap the clevis into the outermost hole in the control horn.

q Remove the masking tape and double-check that both the servo horn and

the elevon are still centred. If necessary, thread the clevis in or out to centre

the elevon, then move the elevon up and down several times to ensure proper

movement.

q Use a couple of pieces of masking tape, taped between the elevon and the wing, to hold the elevon centred.

q Repeat the previous procedures to install the second elevon control linkage

onto the other half of the wing.

q Thin and Thick C/A

q # 2 Philips Head Screwdriver

q Modeling Knife

q Scissors

q Electric or Hand Drill

q (1) Cowling

q (1) Landing Skid

q (2) Plywood Spacer Plates

q (4) M3 x 12mm Machine Screws

q (4) M3 x 18mm Machine Screws

q (4) M3 Flat Washers

q (4) M2 x 10mm Washer-Head Wood Screws

q 1/16" (1.6mm) Drill Bit

q Straight Edge Ruler

q Pencil

q 220 Grit Sandpaper with Sanding Block

q Masking Tape

LANDING SKID AND MOTOR INSTALLATION

YOU'LL NEED THE FOLLOWING PARTS FROM THE KIT:

YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Sin comentarios

Model Tech Mini Mach Racer Especificaciones Pagina 9