Model Tech Mini Mach Racer Especificaciones descargar pdf (Pagina 7)

Page 7

q Push the elevon and hinges into the corresponding three hinge slots in the

trailing edge of the wing.

q Slide one hinge into each of the three hinge slots in the elevon, making sure

that you push each hinge in up to the T-Pins.

IMPORTANT Don't glue the hinges into the elevon yet.

q Allow the C/A to dry for about 15 minutes, then pivot the elevon up and down several times to free up the hinges.

q Remove the T-Pins and push the elevon up against the trailing edge. There

should be no more than a 1/32" (.7mm) wide hinge gap and the outer end of

the elevon should not touch the wing when the elevon is deected.

q While holding the elevon tight against the trailing edge, pivot the elevon

down 45º and apply 5-6 drops of thin C/A to the exposed area of each hinge,

then turn the wing over and repeat for the other side of the hinges.

IMPORTANT Check the integrity of the hinges after the C/A fully cures by gently pulling on the elevon. If one or more hinges feels

loose, apply more C/A to the hinge(s) and allow it to completely cure. The last thing you want is for a hinge to come loose

during ight.

q Repeat the previous procedures to hinge the second elevon to the other

side of the wing.

q Thin C/A

q # 1 Philips Head Screwdriver

q Needle Nose Pliers

q Modeling Knife

q Electric or Hand Drill

q (2) 5-3/4" (146mm) Threaded Wires with Z-Bends

q (2) Nylon Control Horns with Backplates

q (2) Nylon Clevises

q (6) M2 x 16mm Machine Screws

q 1/16" (1.6mm) and 5/64" (2mm) Drill Bits

q Straight Edge Ruler

q Pencil

q Masking Tape



YOU'LL NEED THE FOLLOWING PARTS FROM THE KIT:

YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Sin comentarios

Model Tech Mini Mach Racer Especificaciones Pagina 7