Model Tech Mini Mach Racer Especificaciones descargar pdf (Pagina 10)

Page 10

STEP 2A: INSTALLING THE MOTOR - WITH BOLT-ON THREADED PROPELLER ADAPTER

STEP 1: INSTALLING THE LANDING SKID

q Cut away the covering material from over the landing skid mounting slots in

the bottom of the wing, then test-t and glue the landing skid rmly into place,

using a generous amount of thick C/A.

IMPORTANT Make sure to cut away the covering material from over

the gluing surfaces to ensure a strong bond.

IMPORTANT Two different types of motor are showed installed. The rst type shown in step 2A is an outrunner motor that uses a

backplate mount and a bolt-on threaded propeller adapter. This type of motor requires using the two plywood spacer plates and four

18mm long machine screws to install. The second type shown in step 2B is an outrunner motor that uses a backplate mount and a

slide-on propeller adapter. This type of motor does not require any spacer plates and uses four12mm long machine screws to install.

Please follow the step that matches the motor type that you're using.

q Install the propeller adapter and the backplate mount (both included with

your motor) onto your brushless outrunner motor, following the procedures in

your motor's user's guide.

q Install your motor, using two plywood spacer plates, four M3 x 18mm

machine screws and four M3 at washers, making sure to tighten the machine

screws rmly.

IMPORTANT The two plywood spacer plates are provided to push

your motor out far enough so that the front of the propeller adapter is

approximately 1/16" (1.6mm) in front of the fuselage sides.

IMPORTANT The preinstalled blind nuts in the rewall are spaced to t a majority of 4-hole radial backplate mounts of motors

within the specications of the aircraft. If your motor's backplate mount uses a different mounting hole pattern, you will need to drill new

mounting holes and reinstall the blind nuts to match.

STEP 2B: INSTALLING THE MOTOR - WITH SLIDE-ON PROPELLER ADAPTER

IMPORTANT The preinstalled blind nuts in the rewall are spaced to t a majority of 4-hole radial backplate mounts of motors

within the specications of the aircraft. If your motor's backplate mount uses a different mounting hole pattern, you will need to drill

new mounting holes and reinstall the blind nuts to match.

q Install the backplate mount (included with your motor) onto your brushless

outrunner motor, following the procedures in your motor's user's guide.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Sin comentarios

Model Tech Mini Mach Racer Especificaciones Pagina 10